Page 7
Operational Instructions
Charging
Charge your PBH10 through any USB jack or wall charger. The
LED indicator will begin to blink red when charging. Before
using for the rst time, charge at least 4 hours. Aer the rst
charge, the headset will charge in 2 to 3 hours and the LED
indicator will stop blinking when the charge is complete.
Note: When the battery is fully charged, the LED indicator will change to blue.
Power ON/OFF
Press and hold the ON/OFF button for 1 second to switch the
headset on. The LED will ash blue when powered on. Press
and hold the ON/OFF button for 3 seconds to switch the
headset o. When powering o, the LED will ash blue and
then turn o indicating the headset is o.
Pairing
While the headset is o, press and hold the ON/OFF –
Bluetooth Pairing buttons for 5 seconds to start pairing mode.
Once the headset is in the pairing mode (the LED will ash red
and blue), select ‘LHB18’ among discovered Bluetooth devices
on the phone. If requested, enter the password ‘0000’ to pair
the headset. When connected, you will hear a beep and your
mobile device will show “Paired”.
Note: If the headset is not pair with a Bluetooth device in 3 minutes, it will turn itself o.
To Next Page
Loading...
