Getting started
Replacing a handset
You may need to de-register your handsets if:
You have twelve registered handsets and need to replace a
handset.
-OR-
You wish to change the designated handset number of your
registered handsets.
You must first de-register ALL the handsets, and then re-register
each handset you wish to use.
Please read carefully through all the instructions on this page
before beginning the de-registration process.
To de-register all handsets
1. Press and hold HANDSET LOCATOR on the telephone
base for about 10 seconds (until the IN USE light turns on
and starts to flash), then release the HANDSET LOCATOR
button.
2. Immediately press and release HANDSET LOCATOR again.
You must press HANDSET LOCATOR while the IN USE light
is still flashing. (The light flashes for about seven seconds. If
the light stops flashing, pick up the handset and place it back
into the telephone base, then start again with step one above.)
3. The handset(s) will show CONNECTING... and it will take
about 10 seconds to complete the de-registration process. ALL
handsets will show NOT REGISTERED if de-registration was
successful.
NOT REGISTERED
9
To Next Page
Loading...
Need help?
General
