8
Battery charging
Once you have installed the battery, the screen indicates the
battery status (see the following table). If necessary, place the
handset in the telephone base or charger to charge the battery.
For best performance, keep the handset in the telephone base
or charger when not in use. The battery is fully charged after 16
hours of continuous charging. See the table on page 37 for battery
operating times.
If the screen shows Low battery, you need to charge the handset
without interruption for at least 25 minutes to give the handset
enough charge to use the telephone for a short time. The following
table summarizes the battery charge indicators and actions to take.
Getting started
Battery indicators Battery status Action
The screen is blank, or
shows Place in charger.
The battery has very
little or no charge. The
handset cannot be used.
Charge without interruption
until the screen shows
Low battery or HANDSET X
(at least five minutes).
The screen shows
Low battery and
flashes.
Battery has enough
charge to be used for a
short time.
Charge without interruption
until the screen shows
HANDSET X (at least 25
minutes).
The screen shows
HANDSET X.
Battery is charged. To keep the battery
charged, place it in the
telephone base or charger
when not in use.
NOTE: If you are on a phone call in low battery mode, you hear four short
beeps every minute.
To Next Page
Loading...
Need help?
General
