4
Charging the battery
To charge your tablet, connect the charger to your tablet and
power outlet.
• When using your tablet for the first time, charge the battery
fully (approximately 5 hours).
You are advised to fully charge the battery (
) before first
use. Charging status is indicated by the percentage on screen
while the tablet is powered off. The percentage increases as
the tablet is charged.
To reduce power consumption and energy waste, when battery is
fully charged, disconnect your charger from the plug; switch off
Wi-Fi, GPS, Bluetooth or background-running applications when
not in use; reduce the backlight time, etc.
1.2.2 Power on your tablet
Hold down the Power key until the tablet powers on, if
necessary, unlock your tablet (Swipe, PIN, Password, Pattern).
Store your unlock information in a secure place. If you do not
know your PIN code or if you have forgotten it, contact your
network operator.
Set up your tablet for the first time
The first time you power on the tablet, you should see the
following options:
• Touch get started to set AT&T Read2Go start screen, tap on
get started to begin; or touch not now to skip this step.
To Next Page
Loading...
