UVE415_Wireless_TV_Install_Guide_Inside_Release UVE415_Wireless_TV_Install_Guide_Inside_Release
A
B
C
Connect the provided WAP to your existing Gateway or Inside Unit by plugging one end of the Ethernet cable into
the single port of the WAP and the other end into one of the four Ethernet LAN ports on the back of the Gateway
or Inside Unit. (It is not necessary to power down the Wireless Gateway or Inside Unit when conducting this step.)
Connect the WAP to the provided power cord and plug the cord into a working electrical outlet. Once powered
up, the Power LED light should be green.
Set up the Wireless Access Point (WAP)
Approximate time: 5 minutes
A
B
Complete the installation of the first TV Receiver.
Repeat steps 2 and 3 in this guide with the second TV Receiver.
Adding a second Wireless TV Receiver
Press the OK button on the TV Receiver. On your TV screen, you will see the
gray/white antenna “Searching for Wireless Access Point” (see Figure 3A).
Go to the WAP and press the Wi-Fi Protected Setup (WPS) button
on the front of the unit. You should see a fast-blinking green LED bar
under the WPS button.
Go back to the TV and TV Receiver. Depending upon how quickly you return to your TV, you may see a green
antenna on your TV once the pairing has been successful (see Figure 3B), or you may see the solid green Link
LED light on the front of the TV Receiver. Either indicator means a successful pairing.
• Pairing occurs very quickly. If you are pairing from another room, you may not see the connection
confirmation screen with the green antenna as it appears only momentarily.
• If you see a red antenna as in Figure 3C, see the “Specific issues” section on the back of this guide.
• In order to ensure you have proper signal strength, at least three green LED bars should be displayed on
the front of the TV Receiver (see Figure 3D).
• Please allow up to 10 minutes for your TV Receiver to boot up. Please do not turn off your TV Receiver
during this time. TV programming will automatically appear when the boot-up process is complete.
Congratulations! You have paired your Wireless TV Receiver and are ready to enjoy U-verse TV.
Pair the Wireless TV Receiver to WAP
Approximate time: 10 minutes
3
Figure 1A
Follow the onscreen instructions.
Figure 3B
Successful connection
Figure 3D
Signal strength
Figure 3C
Access Point not found or
connection error
Figure 3A
Searching for Wireless
Access Point (WAP)
Visit att.com/uverse/newcustomer to learn more about the benefits and features of
your AT&T U-verse service.
• New AT&T U-verse customers or current customers
adding a new receiver will need to program the new remote
control (programming instructions are available in the remote
control user guide packaged with the remote control).
WAP
For Receiver replacement
A
B
Unplug the existing receiver from the electrical outlet and remove the power adapter.
Stack the new receiver on top of the old receiver.
Carefully remove one connection at a time from the old receiver and reconnect to the new receiver.
Repeat steps 2 and 3 in this guide to pair the new Wireless Receiver.
C
D
238650_ATT_R1.indd 5 8/29/12 11:18 AM
To Next Page
Loading...
