AT&T U110 - User Manual

Need help?

Do you have a question about the AT&T U110 and is the answer not in the manual?

Summary

Blue cable included with AT&T U110, not used by GBT and should be discarded.

Components to be attached to the AT&T U110 device for connectivity.

The cable used to supply electrical power to the AT&T U110.

The adapter that converts AC power to DC power for the AT&T U110.

Cable used for network connections to the AT&T U110.

Begin the setup by carefully unpacking the AT&T U110 and its accessories.

Hand-tighten the two antennas to the brass antenna connectors on the device.

Connect the power cord to the locking power socket on the back of the AT&T U110.

Insert the Ethernet cable into WAN Port 1 and to your DSL or Cable modem.

Wait until the Power, Online, and VPN lights are steady green, not blinking.

Ensure the AT&T U110 is connected to the GBT network and ready for use.

Use an Ethernet cable to connect your PC or Laptop to LAN Port 1.

General