Atari 400

HOOKING THE TV SET 10 THE
COMPUTER
CONSOLE
STEP
1
Unplug your N set.
STEP 2
Locate the connector
(or connectors) on the
back
of the set labeled VHF. Remove the cable
connected there (you may need a screwdriver
for this).
STEP 3
Attach the cable labeled N on the switch bo x to
the screws labeled VHF on your N set.
STEP 4
Check
whether the cable you have just dis-
connected is thick and round (75 ohm) or flat
(300
ohm).
STEPS
Attach the cable to the TV switch bo x at the
points
labeled 75 ohm or 300 ohm (depending
on
which type of cable you hav e).
STEP 6
If the cable you disconnected in Step 2 w as a 75
ohm (thick and round) cable, you must set your
N to accept a 300 ohm signal. See your N
Owner 's Manual for instructions on how to set
your television for a 300 ohm a ntenn a.
17