STEP 4
Press
the RETURN key again.
You
will
hear the
high-pitched
whistle,
followed
by
a series
of
beeps.
When
the READY message appears again
on the screen,
your
program has been recorded
onto
the cassette.
You
can use this program
whenever
you
need
to
make
another
backup
copy.
ON
DISKETTE
Inserting
the
Diskette
STEP 1
Turn on
your
N
or
monitor
.
Set
the
N/game
switch box
to
the COMPUTER setting, and
tune
to
the channel
you
normally use
with
your
Atari.
STEP 2
Turn on
your
disk drive. When the red
"busy"
light
turns off, open the drive
door
and insert
the
DOS Master Diskette
that
came
with
your
disk
drive.
To
insert the diskette,
hold
it
by
its labeled
edge and insert
it
label side facing up,
bottom
end facing
away
from you.
Be
sure
to
close the
drive
door
once the diskette
is
inserted.
STEP 3
Make sure
that
there are
no
cartridges inserted
in
your
computer's cartridge slot(s). Then,
turn
on
your
computer.
The
disk drive
will
start
whir-
ring, and
you
will
hear a series
of
rapid beeps
from
your
computer
. Soon
you
will
see
some
text
appear on the screen. This list
is
referred
to
as
201
To Next Page
