Since
both
drives are Drive
1,
type
1,
1 (number
1,
comma, number
1)
and press
RETURN.
STEP 3
A
new
prompt
appears on the screen:
INSERT
SOURCE
DISK,
TYPE
RETURN.
Remove the
DOS Master Diskette, and insert the diskette
you
wish
to
copy (the source diskette).
Be
sure
to
close
the
drive door. When
you
are done,
press the
RETURN
key.
You
will hear a series
of
beeps
as
the
computer reads the diskette and
loads the program
into
its memory.
STEP 4
When
the
beeps stop, a
new
prompt
appears
on the screen:
INSERT
DESTINATION
DISK,
TYPE
RETURN.
Remove the original diskette
from the drive and insert the
newly
formatted
diskette (the
destination diskette). Close the
drive door, then press the
RETURN
key.
You
will
hear more beeps
as
the computer writes,
or copies, the information
that
is
in its memory
onto
the
new
diskette.
STEP 5
You
will
be prompted several times
to
insert
the source diskette, then the destination dis-
kette,
as
it
copies the program. This
is
because
the computer cannot load the entire program
into
its memory at one time (the program dis-
kette can hold more information than the com-
puter can hold).
The
computer loads part
of
the program into its memory, then copies it;
then
it
reads a different section
of
the program
204
To Next Page
