Atari 400 - Page 28

HOOKING THE ATARI 810 OR ATARI 1050
DISK DRIVE 10 THE COMPUTER
CONSOLE
STEP 1
Place the disk drive next to your computer con-
sole. Make sure that the chart on the back of the
disk drive
says DRIVE CODE NO . 1 (assuming
that this is your first disk drive).
STEP 2
Locate the wedge-shaped connectors on each
end
of the black three-foot long I/O (Input!
Output) cord that came in the box with your
disk drive.
STEP 3
Insert one of the wedge-shaped connectors into
one of the wedge-shaped holes labeled I/O
CONNECTORS
in the back of your disk drive.
Either
hole will do .
26