Amplifier type: Grounded Source MOSFET based Class A/B, convection cooled.
Output Power: Bass 150W (8Ω), Mid 60W (8Ω), HF 32W (6Ω)
THD+N: <0.003%/-92dB (1kHz, 1dB below rated power, 90kHz BW)
Frequency Response: <2Hz to >200kHz (-3dB).
Crossover Filters: 4th Order Linkwitz-Riley at 380Hz and 3.5kHz.
Balanced Input: Front Panel Mounted Female XLR, pin 2 hot.
Input CMRR: >82dB (10kHz).
Input Impedance: 20kΩ (differential).
Input Sensitivity: 2.2dBu / 1Vrms for full power
Input Sensitivity Control: Continuously Variable from 2.2dBu – 8.2dBu / 1Vrms - 2Vrms (-6dB)
Speaker Level Output: Rear Panel Mounted Neutrik NL8
Bass Boost Control: Continuously variable from 0dB to +3dB.
Limiter: ATC Active FET Momentary Gain Reduction, limiter ‘active’ indicated via LED on speaker front panel.
Power/Clip LED Output: 1 x Rear Panel Mounted 5-Pin Female XLR.
Mains Input: 220-230V or 115V – Factory set. Please observe panel markings and labels!
Power Consumption: Idle 24W/35VA. 1/8th Power 117W/159VA. Full Power 255W/324VA.
Heat Output: Idle 82BTU/hr. 1/8th power 335 BTU/hr. Full Power 358BTU/hr.
Weight – R2-234 Pro: 15kg/33lbs.
Weight – R3-234 Pro: 23.3kg/51.3lbs.
Dimensions: see diagram.
SECTION EIGHT
R2-234 & R3-234 Pro Remote Amp Electronic Specifications
R2-234 & R3-234 Pro Remote Amp Physical Specifications
8.8
8.9
DIAGRAM 14
R2-234 PRO REMOTE AMP
To Next Page
