Amplifier type: Grounded Source MOSFET based Class A/B, convection cooled.
Output Power: Bass 15 0 W (8Ω), Mid 60W (8Ω), HF 32W (6Ω).
THD+N: <0.003%/-92dB (1kHz, 1dB below rated power, 90kHz BW)
Frequency Response: <2Hz to >200kHz (-3dB).
Crossover Filters: 4th Order Linkwitz-Riley at 380Hz and 3.5kHz.
Balanced Input: Front Panel Mounted Female XLR, pin 2 hot.
Input CMRR: >82dB (10kHz).
Input Impedance: 20kΩ (differential).
Input Sensitivity: 2.2dBu/1Vrms for full power.
Input Sensitivity Control: Continuously Variable from 2.2dBu-8.2dBu/1Vrms-2Vrms (-6dB).
Speaker Level Output: Rear Panel Mounted Neutrik NL8.
Bass Boost Control: Continuously variable from 0dB to +3dB.
Limiter: ATC Active FET Momentary Gain Reduction, limiter ‘active’ indicated via LED on speaker front panel.
Power/Clip LED Output: 1 x Rear Panel Mounted 5-Pin Female XLR.
Mains Input: 220-230V or 115 V – Factory set. Please observe panel markings and labels!
Power Consumption: Idle 24W/35VA. 1/8th Power 117 W /159 VA . Full Power 255W/324VA.
Heat Output: Idle 82BTU/ h r. 1/8th power 335 BTU/hr. Full Power 358BTU/ h r.
Weight: 10kg/22lbs.
Dimensions: see diagram.
SECTION EIGHT
R1- 234 Pro Remote Amp Electronic Specifications
R1- 234 Pro Remote Amp Physical Specifications
8.6
8.7
R1-234 PRO REMOTE AMP
DIAGRAM 13
To Next Page
Loading...
