ATD Tools ATD-2088 User Manual

ATD-2088
6" RANDOM ORBITAL SANDER
INSTRUCTION MANUAL
1. Please check tightness of all parts of the tool, and inspect and be sure that it is in good
condition before each use.
2. For best results and to prolong the tool life, install a filter and a lubricator/oiler at the air inlet.
3. The best pressure on tool during operation is from 10 lbf to 15 lbf (5 kgf/cm
3
to 7 kgf/cm
3 )
4. ALWAYS disconnect the air supply when replacing the sand paper or the backing pad.
5. ALWAYS wear e
ye protection, dust mask and gloves during operation.
6. To avoid fatigue, take breaks periodically. 30 minute intervals are suggested.
7. NEVER let tool rotate freely (without load) at high speeds to avoid possible inquiry to human
body and possible tool damage.
8. NEVER touch the rotating part of the tool with hand or body during operation.
9. ALWAYS be sure that the sanding pad is attached flat on the surface of the backing pad
before starting sanding job. (Refer to Illust
ration 1)
10.If you notice any irregular sound or vibration during operation, STOP USING THE TOOL
IMMEDIATELY and check and repair the tool before using again.
11.Be sure to use clean compressed air for operation. Use an air filter in-line with your air
supply to clean impurities out of the compressed air.
12.Before use, lubricate with air tool oil and run the tool run slowly for 20 minutes. Lubricate
regularly after each use, and at suggested intervals of 30 minutes during use to maintain
tool life. An auto lubricator/oiler is recommended.
13.Dirt inside the motor may result in slow rotation and less power of the tool. If this happens,
first disassemble the regulator and press the trigger. Then drop 10-15 drops of air tool oil
from the air inlet into the motor. Restart the motor within 30-40 minutes by re-fitting the air
source and having the motor rotating at low speed for 1-2 minutes. DO NOT USE
GASOLINE, KEROSENE, OR ANY OTHER CAUSTIC CLEANERS as they will cause
damage to your tool.
14.Drain the water out of the air compressor and air hose after each operation.

ATD Tools ATD-2088 Specifications

General

Brand	ATD Tools
Model	ATD-2088
Category	Sander
Language	English

Summary

Instruction Manual Operation and Safety

Pre-Operation Checks and Setup

Inspect tool condition, ensure tightness of parts, and install air filter/lubricator for optimal performance and tool life.

Safe Operation Guidelines

Wear safety gear, avoid high-speed free rotation, never touch rotating parts, and ensure pad is flat on backing pad.

Operational Procedures and Maintenance

Follow correct operating pressure, disconnect air supply when changing parts, lubricate regularly, and drain compressor.

Troubleshooting and Specific Warnings

Stop immediately if irregular sound/vibration occurs. Do not use gasoline or caustic cleaners for motor cleaning.

Parts List and Diagram

Exploded View and Part Numbers

Detailed diagram showing all components of the 6" Random Orbital Sander with corresponding part numbers.

Component Identification

Comprehensive list of parts including ordering part numbers and descriptions for the ATD-2088 sander.