Changing Working Height
The working height of the T
from 44” (110cm) to 68” (172cm) in height. To change the working height:
1. Lock casters (A2) by pressing the lock tab with your foot on each of the locking casters.
2. Grasp a step within the sliding section with one hand while using the other hand to pull one of the
spring loaded locking pins outward. Rotate the pin so it does not slide back into the locking slot.
3. Repeat step 2 on the other side of the sliding section to remove the second spring loaded locking
pin. IMPORTANT: one hand MUST
second spring loaded locking pin is removed from the locked position. This prevents the sliding
section from free falling which could cause serious personal injury.
5. While holding a step within the sliding section with one hand guide one of the spring loaded
locking pins into its corresponding hole in the outside rail.
spring loaded locking pin springs into one of the oval shaped height adjustment holes located in the
side rails of the sliding section.
7. Guide and insert the second spring loaded locking pin through both the outside rail and oval
shaped hole of the inside sliding section rail.
Folding the base section
The foldable Topside Creeper features a folding base section to allow for convenient and compact
storage. To fold the Topside Creeper:
1. Lock casters (A2) by pressing the lock tab with your foot on each of the locking casters.
2. Remove two locking pins from the assembled base section.
on the Topside Creeper base.
4. Grasp each of the two legs (M1 and M2) and raise up to the climbing section.
5. Replace the pins back into their holes for safekeeping.
To Next Page
Loading...