Safety First
WARNING: Failure to follow these safety requirements could result
in personal injury.
This product is a tool to reach what are normally hard to reach places, such as the topside of an
engine compartment for mechanics.
Always inspect the product for damage before each use. Do not use if damage is detected.
Make sure all nuts and bolts are secure before each use.
Always engage the caster locks before using the Topside Creeper.
Always make sure the angle adjustment bar is secure in one of the three position slots before
using.
Always face the Topside Creeper when climbing up or down. Use both hands and keep your
body centered between the rails.
DO NOT USE THE PRODUCT if you tire easily or are subject to fainting spells or disorientation.
DO NOT USE THE PRODUCT if you are taking medication that could impair judgement.
DO NOT USE THE PRODUCT if you are under the inuence of drugs or alcohol.
DO NOT USE THE PRODUCT if you are physically challenged.
DO NOT sit or stand on the chest pad.
DO NOT overload the product. The maximum capacity is 400 lbs (180 kg) which includes body
weight, tools and torque applied to tools.
DO NOT use the Topside Creeper over a running engine.
Operating Instructions
Using the adjustable angle lean-in feature
There are three dierent lean-in angles that allow the user to adjust positioning. This helps the
user to maximize safety and productivity. To adjust angle lean-in:
1. Lock casters (A2) by pressing the lock tab with your foot on each of the locking casters.
2. Push back on the climbing section (O).
3. Move angle adjustment to one of the three notches located on the base.
To Next Page
Loading...