1
Introduction
1.1 Contents
This manual will provide detailed product information and installation instructions for users of the ATESS
HPS series energy storage integrated inverter (hereinafter referred to as inverter) of Shenzhen ATESS
power Technology Co., Ltd. (hereinafter referred to as ATESS). Please read this manual carefully before
using the product and store it in a place convenient for installation, operation and maintenance. Users will
not be informed of any modification of this manual by ATESS. The contents of the manual will be updated
and revised constantly, and it is inevitable that there is a slight discrepancy or error between the manual
and the real product, Please refer to the actual products that you have purchased. Users should contact
their local distributors or log in to our website: www.atesspower.com to download and obtain the latest
version of the manual.
1.2 Target readers
Qualification：
Only professional electricians certified by relevant departments can install this product.
The operator should be fully familiar with the structure and working principle of the entire
energy storage system;
The operator should be fully familiar with this manual;
The operator should be fully familiar with the local standards of the project.
1.3 Symbols
In order to ensure the personal and property safety of the user during installation, or optimally
efficient use of this product, symbols are used highlight the information. The following symbols
may be used in this manual, please read carefully, in order to make better use of this manual.
DANGER
DANGER indicates a hazard with a high level of risk which, if not
avoided, will result in death or serious injury.
CAUTION
CAUTION indicates there is potential risk, if not avoided, could
result in equipment malfunction and property damage.
Caution,risk of electric shock
When battery bank connecting point are exposed, there will be
DC voltage in the equipment DC side; and when output breaker is
on, there is a potential risk of electric shock.
Caution, risk of fire hazard
Suitable for mounting on concrete or other non-combustible
surface only.
Protective conductor terminal
The inverter has to be firmly grounded to ensure the safety of
personnel.
Risk of electric shock, Energy storage timed discharge Electrical
shock danger exists in the capacitor; the cover shall be
moved at least 5 minutes later after all powers are disconnected.
2
Safety instructions
2.1 Notice for use
Inverter installation and service personnel must be trained and familiar with the general safety
requirement when working on electrical equipment. Installation and service personnel should
also be familiar with the local laws and regulations and safety requirements.
Read this manual carefully before operation. The equipment will not be under warranty if
failing to operate according to this manual.
Operation on the inverter must be for qualified electrical technician only.
When inverter operating, don't touch any electrical parts except for the touch-screen.
All electrical operation must comply with local electrical operation standards.
Permission from the local utility company is required before installing the energy storage
system and only professional personnel are qualified for the operation.
1 2
To Next Page
Loading...