ATH-Heinl W42 - User Manual

Questions and Answers

D
David ToddAug 4, 2025
Why does the building circuit breaker blow with ATH-Heinl W42?
- T
  tinafisherAug 4, 2025
  If your ATH-Heinl Wheel Balancers' building circuit breaker blows, several factors could be at play. It could be due to a defective or disconnected brake resistor or condenser, in which case you should check their connections. Damaged or defective motherboards can also cause this issue, requiring you to contact ATH service. Other potential causes include incorrect main machine switch connections, voltage errors from using different adapters (ensure you follow installation instructions), worn middle holes in the rim when tensioning with cones (repair or use special adaptations), or imbalanced tires on the vehicle (readjust without removing the wheel).
J
Jamie ChangAug 9, 2025
How to troubleshoot different balancing results on ATH-Heinl Wheel Balancers?
- S
  Scott SloanAug 9, 2025
  If you are experiencing different balancing results with your ATH-Heinl Wheel Balancers, several factors could be the cause. Ensure the balancing machine is properly anchored to the ground by checking the floor anchor. An incorrect calibration could also be the reason, so try to re-calibrate the machine. Also, inspect the balancing shaft attachment to ensure it is tight and check the balancing shaft for any bending. Additionally, verify the piezo sensors are securely fixed or replace them if defective. Lastly, examine the rim to ensure it is clean and not warped.
A
Amanda GibbsAug 15, 2025
What to do if the engine does not brake on ATH-Heinl W42 Wheel Balancers?
- A
  Ashley LewisAug 15, 2025
  If the engine of your ATH-Heinl Wheel Balancers does not brake or only sporadically brakes, you should check the brake resistor or its connection, as it may be defective or not connected.
J
Justin LeeAug 21, 2025
What to do if buttons do not respond on ATH-Heinl W42 Wheel Balancers?
- L
  Lisa VincentAug 22, 2025
  If the buttons on your ATH-Heinl Wheel Balancers do not respond, check the connection of the button board to the control board, as well as the cable connection. It may be defective.
D
Dr. Stephanie FitzgeraldAug 28, 2025
How to fix rust damage on ATH-Heinl Wheel Balancers?
- A
  Angela GilbertAug 28, 2025
  If your ATH-Heinl Wheel Balancers show heavy rust damage, this is due to damage or lack of corrosion protection. Remove the rust, then clean and restore the surface.