To Next PageTo Next Page
Need help?Do you have a question about the Athena GET RX1 PRO and is the answer not in the manual?
This RX1 PRO kit is intended exclusively for racing use.
General safety instructions to prevent vehicle damages and product issues.
Specific warnings for proper installation and operation of the RX1 PRO ECU.
Remove power restrictors such as DB Killer, catalyst, or lambda sensor before installation.
Locate and disconnect the original ECU connector carefully without damage.
Connect the new RX1 PRO ECU to the OEM connector, ensuring proper engagement.
Install the GET Map Switch following the dedicated section in the manual.
OEM handlebar map change and launch control commands will not work. Use GET Map Switch.
Install the GET WiFi-COM device if included in the kit, following its manual.
Locate the throttle body and rotate the throttle position adjuster counterclockwise for 7 rounds.
Rotate the throttle position adjuster clockwise for 7 rounds to resume initial position.
Steps to take if the engine does not start or runs improperly after calibration.
Declaration of compliance with RoHS Directive for restriction of hazardous substances.
Guidelines for the disposal of waste electrical and electronic equipment (WEEE).
Products are for race use only, not for public roads, and may exceed design limits.
Products are excluded from guarantee due to extreme conditions and potential tampering.
This RX1 PRO kit is intended exclusively for racing use.
General safety instructions to prevent vehicle damages and product issues.
Specific warnings for proper installation and operation of the RX1 PRO ECU.
Remove power restrictors such as DB Killer, catalyst, or lambda sensor before installation.
Locate and disconnect the original ECU connector carefully without damage.
Connect the new RX1 PRO ECU to the OEM connector, ensuring proper engagement.
Install the GET Map Switch following the dedicated section in the manual.
OEM handlebar map change and launch control commands will not work. Use GET Map Switch.
Install the GET WiFi-COM device if included in the kit, following its manual.
Locate the throttle body and rotate the throttle position adjuster counterclockwise for 7 rounds.
Rotate the throttle position adjuster clockwise for 7 rounds to resume initial position.
Steps to take if the engine does not start or runs improperly after calibration.
Declaration of compliance with RoHS Directive for restriction of hazardous substances.
Guidelines for the disposal of waste electrical and electronic equipment (WEEE).
Products are for race use only, not for public roads, and may exceed design limits.
Products are excluded from guarantee due to extreme conditions and potential tampering.
General| Brand | Athena |
|---|---|
| Model | GET RX1 PRO |
| Category | Diagnostic Equipment |
| Language | English |
