GasSens Gas Detection System Section 1 - Overview
O & M Manual
A14-RK, 8/06 1 - 7
For installations where conduit will not be used, cable gland seal fittings must be installed in
the conduit hubs. Plastic cable glands are available from most electrical supply stores. Gland
seals with 1/2" NPT threads will screw directly into the conduit hub. Gland seals are also available
from ATI for installation directly into the enclosures in place of the conduit hubs. Refer to the
parts list for the correct part number of the cable gland seals.
Figure 1-1: Single Module System Enclosure Dimensions (80-0005R)
To Next Page
Loading...