98 Connecting to HDTV
The HDTV Component Video Adapter can be used in place of the standard
A/V Output cable to connect to an HDTV or other component input device,
using component video cables.
Note: Input and output cables lengths should not exceed 50 feet
(15m).
Installing your ATI HDTV video cable
1 Turn on your component input device, and set it to YPbPr input.
Note: See your HDTV or component input device manual for
configuration information specific to your device.
L
You must have a monitor attached to your computer before installing
the ATI HDTV. For proper operation of your ATI Component Video
Adapter, ATI display drivers must be correctly installed.
ATI HDTV Cable
1 ATI HDTV Video Output Cable
2 Backplate of the ATI Graphics Card
3 Male RCA Patch Cables – available from consumer electronics dealer
4 Typical HDTV Video Input Connections
To Next Page
Loading...
