82 Deinterlacing
• Auto Detect lets the multimedia driver to select the best
deinterlacing scheme for different video sources and sizes.
• Bob deinterlacing, when selected, removes every other line of the
video image and is recommended for motion video.
• Adaptive deinterlacing, when selected, reacts to the amount of
motion in the video and apply a media filter on a motion block and
apply weave on the remaining blocks.
• Motion Adaptive deinterlacing, when selected, applies the
advanced motion detection to deinterlace the video.
• Weave does not apply any deinterlacing.
Select a deinterlacing mode
1 From the Tree View pane, expand Video.
2 Click Deinterlacing.
3 Select a deinterlacing mode for the drop-down menu.
Apply your settings
1 Click Apply to save your changes and leave the Catalyst™ Control
Center open.
2 Click OK to save your changes and exit the Catalyst™ Control
Center.
Restore default settings
1 Move the mouse to the bottom right-hand corner of the window.
2 Click Defaults.
Note: Clicking Defaults will restore the defaults for the current view
only. Previous settings are not altered and will be saved once you
click OK.
Discard your settings
•Click Discard to ignore any unsaved changes and restore the
settings that existed when the Catalyst™ Control Center was
opened or the last time Apply was used. Discard does not close the
Catalyst™ Control Center.
Clicking
Discard applies to all features of an aspect, not just the feature in
the current view.
To Next Page
Loading...
Need help?
General
