ATIKA BSV 315 User Manual

Bandsäge
Originalbetriebsanleitung – Sicherheitshinweise – Ersatzteile Seite 2
Band saw
Original instructions – Safety instructions – Spare parts Page 13
Scie à ruban
Notice originale – Consignes de sécurité – Pièces de rechange Page 24
Pásová pila
Originální návod k použití – Bezpečnostní pokyny – Náhradní díly Stránka 36
Båndsav
Original brugsanvisning – Sikkerhedsanvisninger – Reservedele Side 47
Szalagfűrész
Erediti használati utalítás – Biztonsági tudnivalók – Pótalkatrészek 58. oldal
Tračna pila
Originalne upute za rad – sigurnosne upute – rezervni dijelovi Strana 69
Sega a nastro
Istruzioni originali – Indicazioni per la sicurezza – Pezzi di ricambio Pagina 80
Bandzaag
Oorspronkelijke bedieningshandleidning – Veiligheidsinstructies – Reserveonderdelen Pagina 91
Piła taśmowa
Instrukcja oryginalna – Wskazówki bezpieczeństwa – Części zamienne Stronie 102
Bandsåg
Bruksanvisning i original – Säkerhetsanvisningar – Reservdelar Sidan 113
Pásová píla
Originálný návod na použitie – Bezpečnostné pokyny – Náhradné dielce Stránka 124
Tračna žaga
Navodilo za uporabo – varnostni napotki – nadomestni deli Stran 135
Şerit testere
Kullanma kılavuzu – Güvenlik açıklamaları – Yedek parçalar Sayfa 146
BSV 315

ATIKA BSV 315 Specifications

General

Brand	ATIKA
Model	BSV 315
Category	Saw
Language	English

Summary

Extent of Delivery

Characteristic Noise Values

Description of Device and Spare Parts

Proper Use

Residual Risks

Safe Working

Assembly

Replacing the Saw Band

Danger of cutting! Wear gloves when replacing the saw band.

Assemble Saw Table

Assemble the end stop screw (M6 x 35) at the bottom side of the saw table.

Electrical Safety

Preparing for Startup

Start-up

Saw Band Selection

Connect Splinter Extraction

Settings on the Saw

Saw Band Tension

Check the stress by pushing the saw band laterally by 3-5 mm.

Incline of the Upper Band Saw Roll

Adjust the incline of the upper band saw roll (17) to centre the saw band.

Transverse Adjustment of Saw Table

Parallel Stopper

Adjust Cutting Speed

Working with the Saw

Pushing Stick

Used as an extension of the hand to protect against accidental saw band contact.

Adjusting the Upper Saw Band Coping

Cutting Round Work Pieces

Edgewise Cutting of Plain Work Pieces

Cutting Narrow Workpieces

Cutting Wide Workpieces

Cutting Long Workpieces

The Sawing Process

Maintenance and Cleaning

Saw Band Exchange

Danger of cutting! Wear gloves when replacing the saw band.

Adjusting Upper Band Guidance

Check and readjust guidance rolls and support roller after saw band exchange.

Adjusting Lower Band Guidance

Adjust Guide Pins

Adjust guide pins to start approx. 1 mm behind the teeth ground.

Adjust Support Roller

Press support roller against saw band so that it abuts slightly.

Transport

Storage

Possible Faults

Technical Data

Guarantee