WWW.ATKBINDINGS.COM | PROUDLY MADE IN ITALY SINCE 2007 42
5| “RT 10” BINDING ACCESSORIES
The ATK® collection is completed by a series of accessories that increase the comfort and performance of the
bindings; these accessories and the information about the same can be found at the corporate webpage
www.atkbindings.com
6| CARE, MAINTENANCE AND STORAGE
WARNING! Remember to periodically lubricate the rear brake recall sledges with the original ATK®
GREASE (SG01). This maintenance prevents malfunctions and damages to the brake. Video tutorial
available at www.atkbindings.com.
In order to maintain a perfect functionality of the product, including the efficiency of the release
systems, ATK® recommends to periodically lubricate all the joints and rotating contact parts of the
binding with the ORIGINAL ATK® GREASE (COD. SG01) that can be purchased through any ATK®
DEALER; lubricating instructions and basic maintenance guidebooks can be found at the respective
webpage of the interested binding (www.atkbindings.com)
After a medium to long period of inactivity, it is necessary to have the binding checked by an
“SPECIALIZED TECHNICIAN”, in particular the general wear and tear of the binding, the proper
functionality of the systems and the lubrication state of the product.
After each use, carefully clean the binding from dirt, salt, sand or debris, using distilled water; do not use
spears or harsh chemical solvents.
When not used, set the binding as per the downhill mode in order to preserve the elasticity of the
springs. Store it in a dry and protective place; avoid excessive heat.
Do not make any modifications or tampering to the bindings: any of these actions will lead to the
cancellation of the product warranty; these actions could also compromise the functionality of the
bindings and increase the possibility of structural damages and therefore create a greater risk for the
user’s and third party’s safety.
Within 4 years from the purchase of the product, and every 2 years thereafter, the binding must be
submitted to an OFFICIAL ATK® REVISION PROCESS in order to check the good state of the product
parts and the proper functionality of the whole systems.
To Next Page
Loading...