Atlanta EVA - Page 14

Rev.0 13/01/2020
Operator Panel | TURNTABLE - MAST
10
Q
Lift pressure roller, the pressure roller lifts automatically to its
top position at start of cycle.
R Press and hold to lower the pressure roller manually.
S “ Copy
” icon, copies the values of the functions of the selected
program. When pressed, the display (P)
starts flashing and
CPY appears on display (V)
to indicate that a copy and paste
operation is in progress; press the icons P+ and P-
to select the
target program; press the (T)
icon to paste the set of functions
in the selected program, or press RESET
to exit without saving
the parameters in the target program .
T “ Paste
” icon, pastes the values of the functions in the selected
program (see above).
U “ Reload
” icon, reloads the saved values of the selected program.
V 3-digit display indicating the value of the displayed function;
During the cycle or manually moving the film carriage, it indicates
the current height;
The central and left points are decimal points for the values.
When the right point is lit, the icons with the arrows and the
cursor (J)
are blocked and the parameter values cannot be
changed.
W Block keyboard icon; press the icons SAVE (M) ,
F+, F-, BLOCK
KEYBOARD (W) in sequence.
X Functions.
Y Manual commands.