( 4 ) Warning of Electrical Dangers
Electrical Energy
Only use original fuses with specified current rating. Switch off the machine
immediately in case of trouble occurring in the electrical system.
Only a skilled electrician or specially instructed personnel under the supervision
of a skilled electrician may work on the electrical system and always in accordance
with the applicable electrical engineering rules.
If necessary according to the regulations, the power supply to the machine is to be
cut off from parts of the machine for inspection, maintenace and repair work. Safe
working procedures are to be employed while working on the machine in accordance
with local and national legal regulations.
The electrical equipment of the machine is to be checked and inspected at regular
intervals. Loose connections or scorched wires must be replaced at once.
Always ensure that work on live parts and elements is carried out under the
surveillance of a second person who cuts off the power supply in case of danger by
actuating the emergency shut-off or main power switch. Always secure the working
area with safety tape and a warning sign. Only use insulated tools for work.
Ground the supply cable and short-circuit components, such as capacitors with a
ground rod before starting to work on high-voltage assemblies. Cut off the power
supply before doing any work.
Before recommissioning the machine carefully refit and fasten all parts removed for
Before moving the machine always cut off the external power supply. Before
recommissioning reconnect the machine to the mains supply properly.
-This product should be grounded. In the event of an electrical short circuit,
grounding reduces the risk of electric shock by providing an escape wire for
the electric current. This product is equipped with a cord having a grounding
wire with an appropriate grounding plug. The plug must be plugged into an
outlet that is properly installed and grounded in accordance with all local codes
-Improper installation of the grounding plug bears the risk of electrocution.
If repair or replacement of the cord or plug is necessary, do not connect
the grounding wire to any of the flat blade terminal. The wire with a green
insulation sheath (with or without yellow stripes) is the grounding wire.
( 5 ) Gronding Instructions Shall Include the Following
-7-
To Next Page
Loading...