Instruction Book
9829 2115 69 80
CAN Bus address dip switch
Dip switch number Function
1,2,3
(reserved) Normally Off used
for diagnostic purposes
4,5,6,7,8
Binary address selector (valid values= 1 to 31)
bit 4, bit 3, bit 2, bit 1, bit 0) On = 1, Off = 0
Example of address selection:
For CAN Bus node address 1, the dip switch configuration is:
Before switching on the main power supply, check the voltage requirements in
the technical specifications or on the dryer’s data plate.
To Next Page
Loading...