Atlas Copco ETP TBP131-150-13 - Tightening; Buzzer

Operation EN ETP TBP131-150-13
14
© Atlas Copco Industrial Technique AB - 9839 1615 01
■
Increasing the power setting.
■
Increasing rundown speed.
Changes of power settings and/or rundown speed may affect the torque accuracy.
Tightening
As tightening torque increase the reaction force build up equally. Make sure that the tool is in correct work-
ing order and that the controller is correctly programmed. By doing this you avoid unexpected behavior
from the tool, which may result in operator injury.
Rotation Direction for the Tightening
Check that the tool is in the correct running direction by turning the reverse button or reverse ring :
Pistol Grip Models (with side buttons)
■
Press in the reverse switch on the right hand side of the tool, to set the direction clockwise (CW).
■
Press in the reverse switch on the left hand side of the tool, to set the direction counter clockwise
(CCW).
Pistol Grip Models (without side buttons)
■
Double press the function button on the top of the start trigger to shift the direction between clockwise
(CW) and counter clockwise (CCW).
Angle Models
■
Turn the reverse ring to the right, to set the direction clockwise (CW).
■
Turn the reverse ring to the left, to set the direction counter clockwise (CCW).
Soft Start
The soft start function facilitates the screwhead and thread to reach the snug level. The duration of the
soft start is adjustable.
For further information about tightening, see Power Focus 6000 Configuration manual.
Buzzer
This tool is equipped with a buzzer, which can be configured to signal specific events or warnings.
For more information on the buzzer functionality and configuration, see Power Focus 6000 Configuration
Manual.