ETP TBP131-150-13 EN Service
© Atlas Copco Industrial Technique AB - 9839 1615 01
19
8. Rotate the anvil back and forth while filling the oil until no more bubbles are coming out of the Pulse
unit.
9. Spin the complete Pulse unit around while filling the oil, to make sure that there are no air bubbles
left inside of the Pulse unit.
10. Remove the return hose from the oil can and attach the stop plug to the return hose end.
11. Remove the return hose from the outlet opening of the Pulse unit. Put the screw covering the outlet
opening back in position.
12. Now position the Pulse unit in the vise with the inlet opening facing upwards.
13. Remove the syringe from the filling hose and attach the stop plug to the filling hose.
14. Remove the oil filling hose from the Pulse unit.
15. Use the small syringe to extract the right amount of oil, see table Oil Filling.
16. Put the screw covering the inlet opening back in position.
Model Oil reduction (X) from 100% full Pulse unit
ETP TBP/TBP-S 6 0.7 ± 0.05 ml
ETP TBP/TBP-S 8 0.7 ± 0.05 ml
ETP TBP/TBP-S 9 1.1 ± 0.05 ml
ETP TBP/TBP-S 13 1.8 ± 0.05 ml
Oil Filling
To Next Page
Loading...
