4. Push and release the UP button (9).
5. Message “rS” appears on display.
6. Push and release the SET button (8).
7. Message “n” appears on display.
8. Push and release the UP button (9).
9. Message “y” appears on display.
10. Push and release SET (8) to reset service alarm.
11. Message “y” blinks for 3 seconds.
12. Then “rL” is fixed and “°C” blinks on display for about 10 seconds.
The service alarm is now reset.
Setting the service interval
To set the service interval, follow steps 1 to 9:
1. PDP is showing standard view.
2. Push and hold buttons SET (8) and DOWN (10) to enter the menu.
3. Message “SE” appears on display.
Instruction book
2920 7112 50 21
To Next Page
Loading...
Need help?
General
