Atlas Copco GTG25-F120-13 - Adjusting Wheel Guard

GTG25 F120-13 EN Operation
© Atlas Copco Industrial Technique AB - 9839 0065 01
15
Required tools
■
Allen key (stored within the handle)
Instructions
1. Loosen the support handle using an allen key.
2. Adjust the support handle in a suitable position.
3. Tighten the support handle with the screw to the recommended torque.
WARNING Risk of injury
■
Make sure that the wheel guard is put in a suitable position before operating the tool.
Adjusting wheel guard
DANGER Risk of Injury
There is a risk of injury if the tool is used without the wheel guard.
► Always use the tool with the recommended wheel guard.
► Make sure that the wheel guard is positioned correctly and not damaged.
WARNING Risk of severe injury
Air under pressure can cause injury.
► Always shut off the air supply when not in use or before any adjustments.
► Drain the hose of air pressure and disconnect the tool from air supply when not in use or before
any adjustments.
► Always use the correct hose size and air pressure for the tool.
Instructions
1. Pull and hold the spindle lock button.
2. Turn the wheel guard in a suitable position. Position the wheel guard between yourself and the grind-
ing wheel.
WARNING Risk of injury
■
Make sure that the wheel guard is put in a suitable position before operating the tool.
3. Release the spindle lock button.