Atlas Copco QMC41-250-I06

Product Information EN QMC41-250-I06
4
© Atlas Copco Industrial Technique AB - 9839 0326 01
ServAid
ServAid is a portal that is continuously updated and contains Technical Information, such as:
■
Regulatory and Safety Information
■
Technical Data
■
Installation, Operation and Service Instructions
■
Spare Parts Lists
■
Accessories
■
Dimensional Drawings
Please visit: https://servaid.atlascopco.com.
For further Technical Information, please contact your local Atlas Copco representative.
Safety Data Sheets MSDS/SDS
The Safety Data Sheets describe the chemical products sold by Atlas Copco.
Please consult the Atlas Copco website for more information www.atlascopco.com/sds.
Country of Origin
For the Country of Origin, please refer to the information on the product label.
Dimensional Drawings
Dimensional Drawings can be found either in the Dimensional Drawings Archive, or on ServAid.
Please visit: http://webbox.atlascopco.com/webbox/dimdrw or https://servaid.atlascopco.com.
Overview
Applications
The MicroTorque screw fastening systems are ultra low-torque applications.
Normal Environmental Conditions
This product is designed to be safe under the following conditions:
■
Indoor use
■
Altitude up to 2 000 m
■
Operating temperature +5 °C / +41 °F to +40 °C / +104 °F
■
Storage temperature -25 °C / -13 °F to +60 °C / +140 °F
■
Maximum relative humidity 80 % for temperatures up to 31 °C / 89 °F decreasing linearly to 50 % rel-
ative humidity at 40 °C / 104 °F
■
Mains supply voltage fluctuations up to ±10 % of the nominal voltage
■
Transient overvoltages up to the levels of overvoltage category ll
■
Temporary overvoltages occurring on the mains supply
■
Pollution degree 2
■
Ingress protection rating: IP20
Technical Product Data
Technical Product Data can be found on either ServAid, or the Atlas Copco website.
Please visit: https://servaid.atlascopco.com or www.atlascopco.com.