- 41 -
STOPPING To turn off the compressor first press the button "0"
(1). The engine will run some time at minimum speed
to cool down and will stop finally.
The remaining time is shown in the display:
Meanwhile the air receiver is depressurized.
Switch the "ON/OFF" switch to the position "OFF".
Wait until the display is dark.
Switch the battery switch in the "OFF" position.
EMERGENCY STOP
The emergency stop button (2) is only to be used in
emergency situations; not for stopping procedures.
When an emergency stop button is pressed, power to
all outputs is terminated, by the emergency stop itself
(hardware) as well as by the software.
The display will show:
To proceed operation the emergency stop button has
to be unlocked and the alarm has to be acknowledged
by pressing the enter button (3)
The display will show:
To Next Page
Loading...
Need help?
General
