EasyManuals Logo

Atlas AA35 User Manual

Atlas AA35
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
Specifications are subject to change without notice
AtlasSound.com
1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. • TELEPHONE: (800) 876-3333 • FAX: (800) 765-3435
©2006 ATLAS SOUND LP Printed in U.S.A. 000106 ATS002171 RevA 01/06 PP
OWNER'S MANUAL
AA35 MIXER AMPLIFIER
13
Setup – Example 2: Small Convenience Store with Gas Pumps
• Connect the paging mic to INPUT 1.
• Set Dipswitches 3 and 7 to "ON". This sets INPUT 1 to mic level input and routes the paging mic
to Zone 2 output.
• Connect a digital message repeater to INPUT 2. Note: It is common to connect a CD player to the
Input of a message repeater. Now the BGM is routed through the message repeater to INPUT 2.
• Set Dipswitches 2 and 5 to "ON", allowing the message repeater to be routed to the ZONE 2 output
and INPUT 2 will receive a mute command from the paging mic at INPUT 1.
• Connected ZONE 2 1W 8Ω output to 4 series/parallel speakers that are wired in the store to
providing paging, BGM and digital messages. Note: Room variations and speaker selection will
determine number of speakers required. Set the level via the ZONE 2 Level control.
• Connect the gas pump speaker(s) to the 70V output terminals. This will provide paging, BGM, and
digital messages to the outside speakers. Note: When paging from the microphone on INPUT 1
the BGM and digital message signal will be muted on the outside speakers allowing only the page to
be present.
Example 2
* Total loudspeaker impedance to be 8Ω. This output may also be used with 3M
®
pump intercom systems. Contact the factory for details.
On
Off
Low cut
8
On
Off
43
21
Phantom
Mute Rcv
Off
On
Off
On
Off
On
Off
On
5
Zone 2 Assign
6
Input 3 Input 2 Input 1
Input1
7
Input 2
Input 3
Line/Tel
Mic
Off
On
Unswitched Outlet
120V AC 60Hz
Max 500W
Outlet Breaker
125V AC 4A
Push Reset
120V AC 60Hz 100W
Amp In
Line Out A
Line Out B
Pre Out
Input 3 Input 2
L
R
Zone2
100
Level
Mute
Sens
100
Remote
Mute
G-+
Input 1
¡
8
1W
¡
600
Zone 2 Out
-+-+
Speaker Output 35W
COM
25V
¡
8
70V
L
R
£Èä£Ê>VÊV>ÞÊÛ`°]ÊÃ]Ê/8ÊÇx££Ê
nää®ÊnÇÈÎÎÎÎÊÌ>Ã-Õ`°V
77)+
7jbWiIekdZ77I[h_[iC_n[h7cfb_\_[h
CLASS 2 WIRING
To Gas Pump
70V Speakers
Paging Mic
To Store 8Ω
Speakers.*
Message Repeater
0/7%2
0/7 %2
0/7%2
$)')4!,4)-%,%.3
$)' )4!, 4)- %,% .3
$)')4!,4)-%,%.3
/0%.#,/3%
/0% .#, /3%
$)30,!9
$)3 0,!9
2%0%!4
2%0 %!4
3#!.
3#! .
3#!.
3#! .
-%-/29
-%- /29
/0%.#,/3%
$)30,!9
2%0%!4
3#!.
3#!.
-%-/29
$4,
$4,
$4,
3+)0
3+)0
3+)0
3+)0
3+)0
3+)0
0,!9
0,!9
0!53%
0!53%
0,!9 0!5 3%
34/0
34/0
34/0
CD Player

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Atlas AA35 and is the answer not in the manual?

Atlas AA35 Specifications

General IconGeneral
Package weight4630 g
Amplifier class-
Frequency range50 - 20000 Hz
Output impedance8 Ω
Audio output channels3.0 channels
Peak power per channel35 W
Signal-to-Noise Ratio (SNR)- dB
Total Harmonic Distortion (THD)- %
PurposePerformance/stage
Product colorBlack
Volume controlRotary
Bass adjustmentYes
Channels quantity3 channels
Connectivity technologyWired
AC input voltage110 - 120 V
Power source typeAC
Speakers connectivity typePhoenix / RCA
Weight and Dimensions IconWeight and Dimensions
Depth276 mm
Width210 mm
Height93 mm

Related product manuals