Quick Start Steps 7
Cyclops
Installation Of Accessories On The Control Unit And First Start
Open the rear panel of the console. Open the Computer door on the front of the
console. Make sure your computer is free from items used for packaging
and is well ventilated.
Remove the packaging of the monitor
from the compartment of the printer. Take
the monitor and tighten the brackets to
the support on the console
Connect the signal cable and the power
cable to the monitor
Make sure they are connected to the
computer and to the power outlet
Remove the printer from the box and
connect it to the power outlet and the USB
cable from the computer.
Remove the SMART CARD from the plastic
bag and place it correctly in the reader
To Next Page
Loading...
Need help?
General
