Need help?Do you have a question about the Atlas Weather-Ometer Ci5000 and is the answer not in the manual?
General| Brand | Atlas |
|---|---|
| Model | Weather-Ometer Ci5000 |
| Category | Industrial Equipment |
| Language | English |
Provides essential safety warnings and precautions to follow before performing any procedures.
Outlines the main areas covered: Troubleshooting, Calibration, Maintenance, Component Replacement, and Appendix.
Information on how to contact Atlas Service for additional support or inquiries.
Addresses malfunctions related to the xenon lamp system, including ignition and irradiance control issues.
Provides a guide for diagnosing malfunctions like lamp failure to ignite, low/high output, and excessive wattage.
Step-by-step flowchart to diagnose and resolve issues when the xenon lamp fails to ignite.
Flow chart to identify causes and solutions for high or low lamp irradiance output.
Flow chart for diagnosing issues with 2-Sun irradiance levels on the Ci5000 model.
Detailed procedure for troubleshooting lamp ignition failures specifically related to the ignitor component.
Procedure to troubleshoot low or high irradiance levels caused by the wattage regulator.
Details procedures for troubleshooting 2-Sun irradiance failures, including rack speed and relay checks.
Covers replacement of various sensors, including light monitor photodiodes and chamber overtemperature sensors.
Details the LS-8 light monitor, its capsules, photodiode types, and part numbers for different models.
Procedure for accessing and replacing the chamber overtemperature thermostat (S4).
Procedure for replacing the three-wire RTD sensor for chamber overtemperature alarm on early Ci4000 models.
To Next Page
