6.6.3030 MaMast st sysyststem / em / ReRepapaiir ir insnstrtrucucttiionons / s / FoFork rk cacarrrriiagage, e, ttelelesesccopopic ic foforkrks, s, TTFF
12.12. RemovRemove the outee the outer circlipr circlips holdins holding the side beg the side bearing for the saring for the shafthaft, pos. 1, pos. 16.346.34..
13.13. LoosLoosen the en the inteintermedirmediate beate bearing, aring, pospos. 2 fig. 2 figureure6.346.34. Drive the shaft to one . Drive the shaft to one side soside so
that the side bearing can be pressed out of the fork cthat the side bearing can be pressed out of the fork carriage. Remove the bearingarriage. Remove the bearing
and lift the shaft out and lift the shaft out from the fork carriage.from the fork carriage.
14.14. Note the orNote the order in whicder in which the gearh the gear, circlip, circlips and spas and spacers are fitcers are fitted, anted, and then workd then work
them off.them off.
Assembling the fork carriage TFAssembling the fork carriage TF
1.1. Fit the Fit the sprosprockets ckets in the in the tips of ttips of the innhe inner forer forks. Liks. Lightly gghtly grease rease the bethe bearing aring inside inside andand
outside before fitting.outside before fitting.
2.2. Fit thFit the rear e rear shafshaft with st with sprocprocket, ket, stop ristop rings angs and bnd bearinearing houg housingsing. Ch. Check theck that that thee
shaft is not tensioned skew by rotating it by shaft is not tensioned skew by rotating it by hand at least one turn in each direction.hand at least one turn in each direction.
3.3. Fit anFit and add adjust thjust the fork e fork chains chains so thaso that they t they run prun parallearallel with thl with the spre sprockeockets, ants, and sod so
that they give 2-4 mm in that they give 2-4 mm in the middle. Lock the sprockets, stop rings and chainthe middle. Lock the sprockets, stop rings and chain
tensioners. Lightly grease the chains along their tensioners. Lightly grease the chains along their entire length.entire length.
4.4. FiFit tt the he ovoverer-c-cogoggiging ng guguarard.d.
Figure 6.34Figure 6.34 Outer circlips for side bearing and intermediate bearingOuter circlips for side bearing and intermediate bearing
06_016-6_A-Ergo_ TFgafflar.eps
06_016-6_A-Ergo_ TFgafflar.eps
22
11
9797
To Next Page
Loading...