MaMast st sysyststem / em / ReRepapair ir iinsnstrtrucuctitionons / s / FoFork rk cacarrrriaiagege, t, telelesescocopipic fc foorkrks, s, TTFF 6.6.3131
5.5. Fit anFit and adjud adjust the rost the roller atller attachtachments ments by usby using a foing a fork, so rk, so that ththat the plae play is lesy is less than s than 0.30.3
mm. Make sure that the forks are centred on the mm. Make sure that the forks are centred on the inner forks. Remember to lockinner forks. Remember to lock
with the screws.with the screws.
6.6. LightlLightly grey grease aase all the ll the roller roller surfasurfaces aces along thlong their eneir entire letire lengthngth, and f, and fit the it the forksforks..
7.7. Fit the Fit the compcomplete lete motormotor. Fit a. Fit and adnd adjust thjust the lowee lower motor motor char chain so in so that it that it runs runs paralparallellel
between the sprockets, and so that it gives 2-4 mm in tbetween the sprockets, and so that it gives 2-4 mm in the middle. Lock the motorhe middle. Lock the motor
attachment and the sprocket. Lightly grease attachment and the sprocket. Lightly grease the chain along its entire the chain along its entire length.length.
8.8. RemovRemove the e the plug plug in the in the gearbgearbox anox and ched check thck the oil e oil levellevel, whic, which shoh should reuld reach tach to theo the
centre of the output shaft. Top up if necessary.centre of the output shaft. Top up if necessary.
Inspection after assembling the fork carriage TFInspection after assembling the fork carriage TF
Test run the fork carriage and check that:Test run the fork carriage and check that:
•• tthhe e ffoorrkks s ddo o nnoot t jjaamm..
•• ththe e foforrks ks ggo fo fuulllly y iin an annd od outut..
•• ththe ce chahainins rs run un papararallllel el bebetwtweeeen thn the se sprprocockeketsts..
•• ththerere ie is ns no o aabbnnoormrmaal nl nooisisee..
•• ththe oe oveverlorload ad clclututch ch slslipips is in tn the he enend pd posositiitiononss
To Next Page
Loading...