6.6.3232 MaMast st sysyststem / em / ReRepapaiir ir insnstrtrucucttiionons / s / FoFork rk cacarrrriiagage, e, ttelelesesccopopic ic foforkrks, s, TTFF
Adjusting the overload clutch (TF)Adjusting the overload clutch (TF)
The spring tension is not The spring tension is not adjustable since the tensioning nut, pos. 1, adjustable since the tensioning nut, pos. 1, should be fullyshould be fully
screwed in and locked with screwed in and locked with stop screws. The bearing, pos. 2, stop screws. The bearing, pos. 2, and sprocket, pos. 3, shouldand sprocket, pos. 3, should
be lightly lubricated with cold-resistant grease (-35°C), see figurebe lightly lubricated with cold-resistant grease (-35°C), see figure6.356.35..
Warning!Warning!
There must not be any grease on the friction linings.There must not be any grease on the friction linings.
If the overload clutch is damaged, it must be completely replaced.If the overload clutch is damaged, it must be completely replaced.
Figure 6.35Figure 6.35 Overload clutchOverload clutch
06_002_A-Ergo_TFbroms.eps06_002_A-Ergo_TFbroms.eps
2,62,6
33
11
22
To Next Page
Loading...