8.8.3434 HyHydrdrauaulilic c sysyststem em / / ReRepapair ir iinsnstrtrucucttioions ns / S/ Statabibililiseser r cycylilindndererss
Stabiliser cylindersStabiliser cylinders
The stabiliser cylinders have in their The stabiliser cylinders have in their upper end a flexible attachment, the upper end a flexible attachment, the purpose ofpurpose of
which is to compensate for minor irregularities in the floorwhich is to compensate for minor irregularities in the floor
Dismantling and assembling the stabiliser cylindersDismantling and assembling the stabiliser cylinders
1.1. Run Run out out ththe ste stabiabiliseliser cr cyliylindenders rs comcomplepleteltelyy..
2.2. RemovRemove the e the cottecotter in thr in the uppe upper attaer attachmechment. Fint. First grirst grip the p the cylincylinder witder with one h one handhand,,
and then pull out the and then pull out the HCB bolt. This is because of the pretension in HCB bolt. This is because of the pretension in the spring unit.the spring unit.
3.3. Lift tLift the he stabilstabilisers isers slighslightly tly to reto release lease the the pretepretension nsion in thin the spe spring ring unit.unit.
4.4. PuPull ll ouout tt the he babatttterery py plulug.g.
5.5. ReReleleasase te the he hohoseses as and nd plplug ug ththemem..
6.6. RemRemove ove the lthe loweower screr screw thw that goat goes thes throurough thgh the pie pistoston rod n rod endend..
Dismantling and assembling, gasketsDismantling and assembling, gaskets
1.1. UnscreUnscrew thw the pise piston rton rod guod guide ide and pand pull ull the pithe piston ston rod ourod out of t of the cythe cylindelinder pipr pipe.e.
2.2. SuppSupport the ort the pistopiston rod in n rod in a vice a vice in the in the end thend that normat normally sally sits in thits in the strae straddle ddle lift. Ulift. Usese
protective jaws on the vice.protective jaws on the vice.
3.3. UnsUnscrecrew the nuw the nut and ret and removmove the gae the gaskesket holt holder wder with thith the piste piston seaon seals.ls.
Important!Important!
Before fitting, all seals should be lubricated with Before fitting, all seals should be lubricated with hydraulic oil.hydraulic oil.
4.4. AsAssesembmble le in in ththe e rereveversrse oe ordrderer..
Figure 8.16Figure 8.16 Stabiliser cylinderStabiliser cylinder
06_004_A-Ergo_SidoStabHst dB.eps06_004_A-Ergo_SidoStabHst dB.eps
To Next Page
Loading...