ElEleeccttrriiccal al ssyyssttem em / G/ Geenneerraal / l / SSaaffeetty py prroocceedduurreess 1100..33
Edition 2005BEdition 2005B
10 10 Electrical Electrical systemsystem
GeneralGeneral
Safety proceduresSafety procedures
GeneralGeneral
arn ngarn ng
Working with electrical vehicles can result in Working with electrical vehicles can result in personal injury.personal injury.
DuriDuring ang all wll work ork on thon the ele electrectrical ical syssystem, tem, or in or in its iits immemmediatdiate vice vicinitinityy, rin, rings, wgs, watcatcheshes
and other metal objand other metal objects must be removed since the battery hects must be removed since the battery has such a capacity that aas such a capacity that a
short circuit over such an object can result in very serious burn injuries.short circuit over such an object can result in very serious burn injuries.
•• WWorkiorking wng with ith electelectrical rical vehivehicles cles can can resuresult in lt in perspersonal onal injuryinjury. Al. All tel testinsting, tg, troublerouble
shooting and adjusting must be carried shooting and adjusting must be carried out by authorised personnel. The driveout by authorised personnel. The drive
wheel should run free of the floor and be wheel should run free of the floor and be able to rotate freely during work.able to rotate freely during work.
Electronic regulatorsElectronic regulators
•• All eAll eleclectrontronic ric regegulaulators tors in in the the trutruck hck have ave mulmultiptiple sle safeafety sty sysystemtems.s.
•• WheWhen repn replaclacing oing or repr repairairing thing the ele electectronronic regic regulaulatortors, or rs, or remoemoviving cang cablebles, ths, thee
battery should always be battery should always be disconnected.disconnected.
Important!Important!
Incorrectly connected battery cables can destroy the Incorrectly connected battery cables can destroy the electronic regulators.electronic regulators.
Warning!Warning!
During all work on the truck the drive wheel must be lifted During all work on the truck the drive wheel must be lifted up from the floor toup from the floor to
prevent accidents prevent accidents occurring.occurring.
Watches and other metal objects should be Watches and other metal objects should be removed to avoid burn injuries.removed to avoid burn injuries.
After the power has been disconnected to the regulator and work or trouble shooting isAfter the power has been disconnected to the regulator and work or trouble shooting is
toto be carried out there may be carried out there may still be voltage remaining in the constill be voltage remaining in the condensers for a few minutes,densers for a few minutes,
so for this so for this reason observe care when working with current-carrying tools during thesereason observe care when working with current-carrying tools during these
fewfew minminuteutes.s.
To Next Page
Loading...