ATLET SERVICE MANUAL A-ERGOATLET SERVICE MANUAL A-ERGO
This function is tested by switching off the key switch, holding the speed controller inThis function is tested by switching off the key switch, holding the speed controller in
actuated position, and switching the key switch on again. The actuated position, and switching the key switch on again. The truck should then not movetruck should then not move
before the speed controller has been before the speed controller has been in neutral.in neutral.
EElleeccttrriiccaal sl syysstteem / m / GGeenneerraal / l / SSaaffeetty cy chheecckk 1100..55
TTesting of the esting of the motor circuit is motor circuit is not possible since it inot possible since it is a three-phase motor, and neither iss a three-phase motor, and neither is
it necessary.it necessary.
There are different systems that reduce the top speed of the truck and the lifting heightThere are different systems that reduce the top speed of the truck and the lifting height
and load of the forks. These systems are tested by lifting the and load of the forks. These systems are tested by lifting the forks over the switchingforks over the switching
height and loading them over the set weight. A tortoise should then be indicated on theheight and loading them over the set weight. A tortoise should then be indicated on the
MDI display, seeMDI display, see "Multi Function Display Indicator (MDI)" on "Multi Function Display Indicator (MDI)" on page 10.13page 10.13..
To Next Page
Loading...