HDBaseT Scaler with HDMI and
Analog Audio Outputs
Atlona HDVS receiver was designed to smooth the transition from analog to digital displays in
schools and businesses, allowing advanced HDMI display devices to be used with the many VGA
computers still in use. Many displays don’t support the resolutions and refresh rates typical of VGA
sources. In addition, the HDVS-150-RX is compatible with Atlona PoE switchers with HDBaseT
outputs and is a good solution when scaling is required for a specific display.
When used with a matching HDVS-150-TX or HDVS-150-TX-WP, projector control is enabled.
HDBaseT and Power over Ethernet (PoE) allow signal and power over a single category cable, with
RS-232 control capability.
• 1 x AT-HDVS-150-RX
• 3 x Captive screw female connector (5 pin: audio, 3 pin: RS-232, 2 pin: power)
• 1 x 48V DC captive screw power adapter
• 1 x Installation Guide
Package Contents
AT-HDVS-150-RX Installation Guide
Please check http://www.atlona.com/product/AT-HDVS-150-
RX for the most recent firmware update or manual.
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
To Next Page
Need help?
General
