EasyManuals Logo

Atmor thermoboost series User Manual

Atmor thermoboost series
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
Mounting
01 02
06
0403
07
Use mounting screws
that are at least 1 inch
in length.
The water heater must be installed in a manner that prevents
contact with combustible materials. Keep combustible materials at
least two feet away from the heater and hot water output pipe.
The water heater and hot water outlet pipe must be securely out of
the reach of children to prevent tampering with controls or contact
with an extremely hot pipe.
The mounting surface
must be solid and secure.
The unit must be installed
in an upright position with
the water inlet and outlet
at the bottom.
Make sure the unit is
level prior to securing the
mounting screws.
If installing the heater on an upper oor or in an attic, be sure
installation is in compliance with local code. Install a drip pan
with drainage, or a leak detector and automatic shutoff valve, to
prevent damage in case of a leak.
5
05
Do not install the unit
above electrical boxes
or junctions.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Atmor thermoboost series and is the answer not in the manual?

Atmor thermoboost series Specifications

General IconGeneral
BrandAtmor
Modelthermoboost series
CategoryThermostat
LanguageEnglish