2.1 prevent falls
When you hang up a device, please verify that it will be supported by the accessory
assembly, truss or stand, and that is not damaged. As well as the rest of the rigging accessories.
2.2 Prevention of concussion
The electrical connection must match the corresponding characteristics, before installing,
make sure that the voltage is adequate and that it is a power outlet with protection.Each
equipment must be properly grounded.
2.3 prevent burns or fire
1. For no reason should the equipment be mounted directly or near a surface or
You must consider a distance not less than 3.0 meters.
2. Do not short-circuit the fuse when you need to replace it, use a fuse with the value
suitable.
3. Avoid directly seeing the light source
4. During operation, the equipment case becomes very hot, allow the equipment to cool for
at least 20 minutes before handling.
6. Never cover the equipment with any items, this could cause overheating and fire.
3.
PACKING AND TRANSFER
3.1 unpacked
Note: Before unpacking, check that the box is not damaged, this could mean that the
equipment has had some damage as well, make sure the equipment is in good condition
before switching it on, in case of being damaged put the complaint before your parcel service
or freight
To Next Page
Loading...