5. To turn OFF a Chime Alert, Press 4 o’clock button. To turn ON a Chime Alert, Press 2
o’clock button.
6. Press 8 o’clock button to confirm.
7. After a Chime alert is turned ON, the watch will announce the HOUR every one hour.
Manual Signal Reception:
Set the correct Time Zone before initiating Manual Signal Reception. Go to “Time Zone
Setting” section for details. Follow below if you want your watch to search for signal
immediately and not wait overnight.
Note: the below steps might require sighted assistance.
While the watch is in normal running mode:
1. Press and hold the 10 o’clock button until the second hand stops at the 7 o’clock position.
2. The watch takes about 5 to 15 minutes to pick up the radio signal. Wait until the watch
has finished the signal receiving procedure.
3. After successful signal reception, the watch will show the correct time after the fast
running second-hand stops.
4. Push 8 o’clock button once. The watch will say the status of the reception.
5. If reception was successful, the watch will say “USA Time Updated.”
6. If reception failed, the watch will say “USA Time Not Updated.”
7. You may move watch to another location where reception may be more favorable and try
manual reception again or wait overnight for better possible reception.
Note: This process stops the watch from talking, so you may seek sighted assistance during this
setting phase.
Manual Time Setting:
You should use this function if traveling to countries with no signal reception. You must also set
correct time of day (AM/PM) and time zone when you come back from traveling to other
countries.
1. hold the 8 o’clock button for more than 5 seconds until the watch says “Set Alarm, Press
10 o’clock button to set”
2. Push 8 o’clock button 4 more times, until the watch says, “Set time. Press 10 o’clock
button to set”
3. press 10 o’clock button
To Next Page
Loading...