ATOMSTACK R2 V2 - Configure Rotary Setup Parameters

7
Use LightBurn
2. Open the Rota Setup window and set the parameters
2.1 Open the Rota Setup window: Click "Laser Tools" on the toolbar and then click "Rota Setup"
2.2 Set the correct parameters in the Rota Setup window: As shown in the gure
Steps:
(1) Select the rota type: Roller Type
(2) Turn on "Enable Rota"
(3) Select the "Y Axis" rota axis
(4) Input the parameters (xed value) of the rota equipment
(5) Enter your object parameters:Enter the actual measured perimeter or diameter
value, and another value will be automatically generated
Rota Setup
Parameters of rotation
The parameters of your sculpted odject