ATrack AK11 - User Manual

To Next Page

1 | P a g e

ATrack AK11 Installation Guide

1 Wiring Summary for Standard Tracking

Wiring:

Main Power – RED and BLACK wires (PIN 13 and PIN 14)

Connect to a direct and constant power supply.

NOTE: If the vehicle has an isolator, please run the connection before the isolator so that it

does not interfere with the main power of the unit when the engine is OFF.

Ignition – YELLOW wire (PIN 1)

Connect to ignition.

Pins 3-12 – Various Coloured wires

Do not connect unless instructed otherwise. Wires for use with other inputs/outputs.

Location:

• Install the unit inside hidden areas of the dashboard or behind the glovebox.

• Where possible, place the unit with LED lights facing OUT.

• The GPS signal will not travel through metals – Avoid placing the unit under closed

metal surfaces. The GPS signal will travel through NON ferrous materials. EG: Glass,

Plastics

Need help?

Do you have a question about the ATrack AK11 and is the answer not in the manual?

Summary

Details on connecting main power, ignition, and accessory wires for standard tracking.

Recommendations for installing the unit inside the vehicle for best GPS signal reception.

Comprehensive table detailing pin assignments, functions, colors, and notes for the device's I/O connector.

General

Weight	150g
GPS Accuracy	2.5m CEP
GSM Frequency	850/900/1800/1900 MHz
Connectivity	GSM, GPRS, SMS
Input Voltage	9-36V DC
Analog Inputs	1
Outputs	2
G-Sensor	Yes
GPS Sensitivity	-167 dBm
Certifications	CE, FCC, RoHS
Storage Temperature	-40°C to 85°C
Battery	Li-Polymer
Antenna	Internal GSM and GPS antennas
Power Consumption (Standby)	5mA at 12V