ATrack AK7 User Manual

AK7
User Manual
Revision:
03
Revision Date:
2016/02/22
ATrack Technology Inc.
4F., No. 12, Wunhu St., Neihu Dist.,
Taipei City 11445 Taiwan (R.O.C.)
Tel: +886-2-27975852
Fax: +886-2-27974030
http://www.atrack.com.tw

ATrack AK7 Specifications

General

Operating Voltage	9-36V DC
GSM	Quad-band 850/900/1800/1900 MHz
GPS Chipset	u-blox All-in-One GPS receiver
GPS Accuracy	2.5m CEP
GPS Sensitivity	-162 dBm
G-Sensor	3-axis accelerometer
Serial Port	RS232
Antenna	Internal GPS and GSM antenna
Digital Outputs	2
Communication	SMS, GPRS
Update Rate	1 Hz
Battery Backup	Yes
Certifications	CE, FCC, RoHS
Operating Temperature	-20°C to +70°C

Summary

1. Notification

1.1. Disclaimer

Legal disclaimer regarding product usage and liability for damages or injuries.

1.2. Copyright

Details intellectual property rights and restrictions on document content disclosure.

1.3. Warning

Cautionary note about potential hazards of connecting input wires by inexperienced installers.

2. Introduction

3. System Architecture

4. Installation

4.1. Package Content

Lists the devices and accessories included in the AK7 product package for verification.

4.2. SIM Card Installation

Instructions for installing a SIM card into the AK7 device, specifying voltage compatibility.

4.3. Power I/O Connector

4.4. Serial Port Connector

4.5. GPS Antenna Installation

4.6. Device Installation

4.7. LED Indicators

5. Configuration

5.1. Set up a Device Using the ATConfigure Tool

Guide to configuring AK7 parameters using the ATConfigure Tool software.

5.2. Connect a Device Using HyperTerminal

5.3. Connect a Device to a Remote Server

6. AT$IOCG Command Reference

6.1. Configure or Query I/O Pin Characteristics

Details the AT$IOCG command syntax for managing I/O port settings.

7. Firmware Upgrade

8. Appendix

8.1. Hardware Specification

Technical specifications for various AK7 models, including dimensions, power, and communication.

8.2. FCC Regulations