PAUSE
OFFFC:0%
OUTPUT OPTION
ENTER
EXIT
ADVANCED MENU
ENTEREXIT
PELLETS TRIM
ENTEREXIT
BURN-DOWN
ENTER
EXIT
LOGGING
ENTEREXIT
The burner is in stand-by mode.
Here you can change the burner output. Option 1 =
12kW, 2 = 15kW, 3 = 18kW.
These outputs can be further varied in the Advanced
menu.
Here you can adjust the amount of pellets fed in. Most
needed if the correct pellets weight has been adjusted
under Pellets trim in the Advanced menu.
If you want to clean the burner or shut it down for
other reasons during the operation, press “M“ button
and a burning out will take a place. For restarting the
burner after ash removal, press “M”.
If the burner stops and the alarm is triggered, this
internal record can be of a help when trouble-
shooting. The latest 10 different fault codes will be
saved here. For more informations of these fault
codes, see " Trouble-shooting".
For accessing the Advanced menu you need a
password (code) and must be familiar with the burners
program functions.
Menu texts
Push the button”M”
Push the button”+”.
Push the button”+”
Push the button ”+”.
Push the button ”+”.
10
To Next Page
Loading...
