ATTACK PELLET Series - S2 Burner: Settings Management and Logging; Settings:; Logging:

LOGGING
ENTER
> EXIT
SETTINGS
ENTER
< > EXIT
Here the settings can be saved that have been made during
installation, or you can reload the factory or installation settings.
Three main options are accessible: “Load settings”, “Save
settings” and “Factory settings”.
-“Load settings” means that you can retrieve earlier saved
settings.
-“Save settings” means that here the final settings made by
the installer of the burner can be entered. This faciliates
the retrieval of these settings when there have been too
many changes of parameters.
-“Factory settings” are the original settings that can be
reloaded here.
Here all faults are saved and displayed as well as how often each
fault occured. Also the total number of ignition attempts made can
be read .
Here you will find four options: "No. of faults", "No. of ignitions
1", "No. of ignitions 2", "Latest faults".
-“No. of faults” displays each fault code separately, e.g. E-
CODE 10(X). See page 17 for fault codes and their explanation
Settings:
Logging:
27
-“No. of ignitions 1” shows how many ignitions have taken place.
-“No. of ignitions 2” shows how many second ignition attempts the burner has made (i.e. how
often the first attempt failed).
“Latest faults” shows fault codes in the order of the occurence of each fault. Faciliates trouble-
shooting.